LOCATIONS USING URETHANE FOAM AND FOAM MATERIAL
- Introduction of noise was prevented by inserting urethane foam inside the centre pillar.
- Introduction of noise was prevented by adding acoustic foam materials inside each pillar, side roof rail and wheel house arch interior.
- High rigidity foam materials were added inside the front sidemember (right side) and rear floor sidemember to heighten panel rigidity.
CAUTION- Never use a gas burner or burn the areas using foam materials.
- When cutting the parts using foam materials, ensure to use tools (air saw, etc.) that do not generate fire.
- If there is residual foam materials remaining on the cut section (body side) then weld after removing the foam materials from periphery of the welding area.
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)