[16] ENGINE ELECTRICAL - - CHARGING SYSTEM - ALTERNATOR ASSEMBLY - REMOVAL AND INSTALLATION <4G64-SOHC>PRINT PAGE / INDEX / PRIOR / NEXT
REMOVAL AND INSTALLATION <4G64-SOHC>
Pre-removal Operation
  • Under Cover Removal (Refer to GROUP 51, Under Cover ).
  • Drive Belt Removal (Refer to GROUP 11A, Crankshaft Pulley ).
Post-installation Operation
  • Drive Belt Installation (Refer to GROUP 11A, Crankshaft Pulley ).
  • Drive Belt Tension Adjustment (Refer to GROUP 11A, On-vehicle Service ).
  • Under Cover Installation (Refer to GROUP 51, Under Cover ).

   



Removal steps


1.
 Oil level gauge and guide


2.
 O-ring


3.
 Control harness connector


4.
 Harness bracket


5.
 Power steering oil pressure hose clamp


6.
 Brake fluid level sensor connector connection


7.
 Brake reservoir tank connecting bolts


8.
 Brake master cylinder connecting nuts


9.
 Brake pipe connection


10.
 Alternator brace


11.
 Water pump pulley


12.
 Alternator connector
<<A>>
13.
 Alternator assembly

REMOVAL SERVICE POINT
<<A>> ALTERNATOR ASSEMBLY REMOVAL
     CAUTION
     Do not jack up the engine more than necessary as the oil pan will be damaged.
  1. Jack up the engine.
       
    1. Apply a protective tape around the brake lines.
    1. Move up the brake master cylinder to create sufficient clearance between it and the intake manifold.
         
      1. Remove the alternator assembly as shown.
      [16] ENGINE ELECTRICAL - - CHARGING SYSTEM - ALTERNATOR ASSEMBLY - REMOVAL AND INSTALLATION <4G64-SOHC>PRINT PAGE / INDEX / PRIOR / NEXT
      ©2004 Mitsubishi Motors Corporation