E3. CHANGE ENGINE
OIL
- Start the engine and allow it to warm up until the temperature of the coolant reaches
80°C to90°C .
- Stop the engine and remove the engine oil filler cap.
- Remove the drain plug to drain oil.
CAUTION- Install a new drain plug gasket so that it faces in the direction shown in the illustration, and then tighten the drain plug to the specified torque.
)
Tightening torque: 39 ±
5 N·m
)
)
- Refill with specified quantity of engine oil.
Specified Engine Oil (API classification): SE or higher
Total quantity (Includes volume inside oil filter): 4.3 L
Total quantity (Includes volume inside oil filter): 4.3 L
NOTE:
- If SE grade engine oil or higher is difficult to obtain, use API classification SD engine oil.
- SAE 0W-30, and 5W-40 engine oils can only used it they meet ACEA A3 and API SG (or higher) specification.
- Remove the dipstick from the engine, and check whether or not the engine oil level is within the range between MAX and MIN.
- Install the engine oil filler cap.
- Start the engine and run it for a few minutes.
- Stop the engine and check the oil level.