[11C] ENGINE MECHANICAL <4G6-DOHC> - - ON-VEHICLE SERVICE - IDLE MIXTURE CHECKPRINT PAGE / INDEX / PRIOR / NEXT
IDLE MIXTURE CHECK
           
    1. Before inspection, set the vehicle to the pre-inspection condition.
    1. Turn the ignition switch to "LOCK" (OFF) position.
    1. Connect the MUT-II/III to the diagnosis connector or connect a tachometer to the engine speed detection connector.
    1. Connect a timing light.
         
      1. Start the engine and let it run at idle.
      1. Check that ignition timing is at the standard value.
        2. Standard value: approximately 5° BTDC
      1. Run the engine at 2,500 r/min for 2 minutes.
      1. Set the CO, HC tester.
      1. Check the CO contents and the HC contents at idle.
        2. Standard value
        • CO contents: 0.5% or less
        • HC contents: 100 ppm or less
      1. If there is a deviation from the standard value, check the following items:
        • Diagnosis output
        • Fuel pressure
        • Injector
        • Ignition coil, spark plug cable, spark plug
        • EGR control system
        • Evaporative emission control system
        • Compression pressure
        NOTE: Replace the three way catalyst when the CO and HC contents are not within the standard value, even though the result of the inspection is normal on all items.
      [11C] ENGINE MECHANICAL <4G6-DOHC> - - ON-VEHICLE SERVICE - IDLE MIXTURE CHECKPRINT PAGE / INDEX / PRIOR / NEXT
      ©2004 Mitsubishi Motors Corporation