)
)
)
- Before inspection, set the vehicle to the pre-inspection condition.
- Turn the ignition switch to "LOCK" (OFF) position.
- Connect a tachometer or connect the MUT-II/III to the diagnosis connector.
)
- Attach a three-way joint to the vacuum hose between the fuel pressure control solenoid valve and the air intake plenum, and connect a vacuum gauge.
- Start the engine and check that idle speed is within the standard valve.
Standard value: 750 ±
100 r/min
- Check the intake manifold vacuum.
Limit: Minimum 60 kPa
- Turn off the ignition switch.
- Remove the vacuum gauge and the three-way joint, and then connect the vacuum hose.
- Remove the engine tachometer or the MMUT-II/III.