)
| Crankshaft front oil seal removal steps |
|||
|---|---|---|---|
| • |
Valve timing belt, balancer timing belt (Refer to  ). |
||
>>D<< |
1. |
Crankshaft balancer shaft drive sprocket |
|
| 2. |
Crankshaft key |
||
| >>C<< |
3. |
Crankshaft front oil seal |
|
| Crankshaft rear oil seal removal steps |
|||
| • |
Transmission assembly (Refer to GROUP 23A, transmission assembly ). |
||
| <<A>> |
>>B<< |
4. |
A/T drive plate bolts |
| 5. |
A/T drive plate adapter plate |
||
| 6. |
A/T drive plate |
||
| 7. |
Crankshaft bush |
||
| >>A<< |
8. |
Crankshaft rear oil seal |
REMOVAL SERVICE POINT
)
- Use special tool flywheel stopper (MD998781) to secure the A/T drive plate.
- Remove the A/T drive plate bolts.
INSTALLATION SERVICE POINTS
)
- Apply a small amount of engine oil to the entire inner diameter of the oil seal lip.
- Use the following special tools to press-fit the oil seal.
- Installer bar (MB990938)
- Crankshaft rear oil seal installer (MD998776)
- Use special tool flywheel stopper (MD998781) to secure the A/T drive plate in the same manner as removal.
- Tighten the A/T drive plate bolts to the specified torque.
Tightening torque: 132 ±
5 N·m
)
- Apply a small amount of engine oil to the entire inner diameter of the oil seal lip.
- Apply a small amount of engine oil to the outer diameter of special tool crankshaft front oil seal guide (MD998285) and install it to the crankshaft.
- Use special tool crankshaft front oil seal installer (MD998375) to press-fit the oil seal.
)
- Clean or degrease the front case, the crankshaft and the crankshaft balancer shaft drive sprocket as shown.
NOTE: Also clean the degreased surfaces.
- Install the crankshaft balancer shaft drive sprocket in the direction shown in the illustration.