ACCELERATOR CABLE CHECK AND ADJUSTMENT <4G69-L.H. DRIVE VEHICLES>
- Turn A/C and lights OFF. Inspect and adjust at no load.
- Warm engine until stabilized at idle.
- Confirm idle speed is at standard value.
Standard value: 750 ±
100 r/min
- Stop engine. [ignition switch: LOCK (OFF) position].
- Confirm there are no sharp bends in the accelerator cable.
- Check the inner cable for correct slack.
Standard value: 1.0 -
2.0 mm
)
- If there is too much slack or no slack, adjust play by the following procedures.
- Loosen the lock nut and adjusting nut to release the cable.
- Tighten the adjusting nut until the inner cable play is at the standard value, and then tighten the lock nut.