[17] ENGINE AND EMISSION CONTROL - - ENGINE CONTROL - ACCELERATOR CABLE AND PEDAL <4G63, 4G64, 4G69-L.H. DRIVE VEHICLES> - REMOVAL AND INSTALLATIONPRINT PAGE / INDEX / PRIOR / NEXT
ACCELERATOR CABLE AND PEDAL <4G63, 4G64, 4G69-L.H. DRIVE VEHICLES>
REMOVAL AND INSTALLATION
Post-installation Operation
Adjusting the Accelerator Cable (Refer to <4G63, 4G64> or <4G69-L.H. drive vehicles>).

   
      Accelerator cable assembly removal steps
    1.
 Inner cable connection (Accelerator pedal side)
    2.
 Inner cable connection (Throttle body side or accelerator pedal position sensor side)
    3.
 Accelerator cable assembly
    4.
 Accelerator cable bracket <4G69-L.H. drive vehicles>
    5.
 Holder <R.H. drive vehicles>
      Accelerator pedal assembly removal steps
    1.
 Inner cable connection (Accelerator pedal side)
    6.
 Accelerator pedal assembly


7.
 Push-on spring nut


8.
 Accelerator arm and accelerator pedal pad assembly


9.
 Bushing


10.
 Spring


11.
 Stopper


12.
 Accelerator pedal bracket


13.
 Accelerator arm

>>A<<
 14.
 Accelerator pedal pad


15.
 Accelerator pedal stopper

INSTALLATION SERVICE POINT
>>A<< ACCELERATOR PEDAL PAD INSTALLATION
 CAUTION
 To prevent damages to the Pedal Pad, warm the thumb area of the Pedal Pad with a dryer, etc. prior to assembling it.
NOTE: If it is difficult to assemble, apply soapy water to the thumb area to enhance the assembling process.
[17] ENGINE AND EMISSION CONTROL - - ENGINE CONTROL - ACCELERATOR CABLE AND PEDAL <4G63, 4G64, 4G69-L.H. DRIVE VEHICLES> - REMOVAL AND INSTALLATIONPRINT PAGE / INDEX / PRIOR / NEXT
©2004 Mitsubishi Motors Corporation