[17] ENGINE AND EMISSION CONTROL - - ENGINE CONTROL - SYMPTOM PROCEDURES - Inspection Procedure 4: Accelerator Pedal Operation is not Smooth (Over Acceleration) <4G63, 4G64, 4G69-L.H. drive vehicles>PRINT PAGE / INDEX / PRIOR / NEXT
Inspection Procedure 4: Accelerator Pedal Operation is not Smooth (Over Acceleration) <4G63, 4G64, 4G69-L.H. drive vehicles>
DIAGNOSIS PROCEDURE
STEP 1. Check the accelerator pedal.
Q: Is the accelerator pedal loose?
YES:  Tighten the fasteners. Then go to Step 4.
NO:  Go to Step 2.
STEP 2. Check the accelerator cable wiring.
Q: Is the accelerator cable routing bent sharply?
YES:  Correct the cable routing Then go to Step 4.
NO:  Go to Step 3.
STEP 3. Check the accelerator cable lubricant.
Q: Is the accelerator cable lubricated sufficiently?
YES:  Go to Step 4.
NO:  Refill or replace the lubricant. Then go to Step 4.
STEP 4. Retest the system.
Q: Does the accelerator pedal work normally?
YES:  The procedure is complete.
NO:  Return to Step 1.
[17] ENGINE AND EMISSION CONTROL - - ENGINE CONTROL - SYMPTOM PROCEDURES - Inspection Procedure 4: Accelerator Pedal Operation is not Smooth (Over Acceleration) <4G63, 4G64, 4G69-L.H. drive vehicles>PRINT PAGE / INDEX / PRIOR / NEXT
©2004 Mitsubishi Motors Corporation