[17] ENGINE AND EMISSION CONTROL - - ENGINE CONTROL - SYMPTOM PROCEDURES - Inspection Procedure 5: Accelerator Pedal Operation is not Smooth (Over Acceleration) <4G69-R.H. drive vehicles>PRINT PAGE / INDEX / PRIOR / NEXT
Inspection Procedure 5: Accelerator Pedal Operation is not Smooth (Over Acceleration) <4G69-R.H. drive vehicles>
DIAGNOSIS PROCEDURE
STEP 1. Check if the accelerator pedal and the accelerator pedal are installed correctly.
Q: Are the accelerator pedal and the accelerator pedal installed correctly?
YES:  Go to Step 2.
NO:  Replace and reinstall the accelerator pedal (Refer to ). Go to Step 3.
STEP 2. Check the MUT-II/III diagnosis code
Q: Is any diagnosis code set?
YES:  Refer to GROUP 13C, Troubleshooting - Inspection Chart for Diagnosis Code .
NO:  Go to Step 3.
STEP 3. Retest the system.
Q: Does the accelerator pedal work normally?
YES:  The procedure is complete.
NO:  Return to Step 1.
[17] ENGINE AND EMISSION CONTROL - - ENGINE CONTROL - SYMPTOM PROCEDURES - Inspection Procedure 5: Accelerator Pedal Operation is not Smooth (Over Acceleration) <4G69-R.H. drive vehicles>PRINT PAGE / INDEX / PRIOR / NEXT
©2004 Mitsubishi Motors Corporation