[13A] MULTIPORT FUEL INJECTION (MPI) <4G63> - - ON-VEHICLE SERVICE - ON-VEHICLE SERVICEPRINT PAGE / INDEX / PRIOR / NEXT
ON-VEHICLE SERVICE
ON-VEHICLE SERVICE
THROTTLE BODY (THROTTLE VALVE AREA) CLEANING
  1. Remove the air intake hose from the throttle body.
  1. Spray cleaning fluid on a clean cloth.
    2.  CAUTION
    • Do not spray the cleaning fluid directly to the throttle valve.
    • Make sure the cleaning fluid does not enter the motor from the bypass line. Also make sure it does not enter the sensor through the shaft.
    • Be careful not to rub off the molybden applied around the throttle valve shaft.
       
    1. Wipe off the dirt around the throttle valve with the cloth sprayed with cleaning fluid.
    1. Attach the air intake hose.
    1. Adjust the basic idle speed (Refer to ).
    [13A] MULTIPORT FUEL INJECTION (MPI) <4G63> - - ON-VEHICLE SERVICE - ON-VEHICLE SERVICEPRINT PAGE / INDEX / PRIOR / NEXT
    ©2004 Mitsubishi Motors Corporation