)
)
- Disconnect the throttle position sensor connector.
- Measure the resistance between the throttle position sensor side connector terminal No. 1 and terminal No. 4.
Standard value: 3.5 -
6.5 kΩ
- Measure the resistance between the throttle position sensor side connector terminal No. 2 and terminal No. 4.
| Throttle valve slowly open until fully open from the idle position |
Changes smoothly in proportion to the opening angle of the throttle
valve |
- If the resistance is outside the standard value, or if it doesn't change smoothly, replace the throttle position sensor.
NOTE: For the throttle position sensor adjustment procedure, refer to 
.
.