|
Inspection Procedure
12: Hesitation, Sag,Poor Acceleration, Stumble or Surge <DOHC>
|
|
COMMENTS ON TROUBLE SYMPTOM
- Failure is possibly caused by failed ignition system, improper air-fuel ratio,
improper compression pressure or other faults.
|
PROBABLE CAUSE
- Failed air-fuel ratio control system
- Failed intake and exhaust system
- Failed emission control system
- Improper compression pressure
|
| |
| |
| STEP 1. MUT-II/III diagnosis code Q: Diagnosis code set?
YES:
Inspection chart for diagnosis code (Refer to  ).
NO:
Go to Step 2  .
|
| STEP 2. Check injector for operating sound. - Check injector for operating sound (Refer to ).
Q: Can operating sound be heard?
YES:
Go to Step 3 .
NO:
- Check the injector system of the defective
cylinder.
- (Refer to code No. P0201: No. 1 injector system )
- (Refer to code No. P0202: No. 2 injector system )
- (Refer to code No. P0203: No. 3 injector system )
- (Refer to code No. P0204: No. 4 injector system )
|
| STEP 3. MUT-II/III data list - Refer to Data list reference table .
- Item 13: Intake air temperature sensor
- Item 14: Throttle position sensor
- Item 21: Engine coolant temperature sensor
- Item 25: Barometric pressure sensor
Q: Are the check results normal?
YES:
Go to Step 4 .
NO:
Perform the diagnosis code classified check procedure for the sensor that has
shown an abnormal data value (Refer to Inspection Chart for Diagnosis Codes ).
|
| STEP 4. Check Purge control solenoid valve itself. - Check Purge control solenoid valve itself (Refer to GROUP 17 -
Emission
Control System -
Evaporative Emission Control System ).
Q: Is the check result normal?
YES:
Go to Step 5 .
NO:
Replace purge control solenoid valve.
|
| STEP 5. Check EGR control solenoid valve itself. - Check EGR control solenoid valve itself [Refer to GROUP 17 -
Emission
Control System -
Exhaust Gas Recirculation (EGR) System].
Q: Is the check result normal?
YES:
Go to Step 6 .
NO:
Replace EGR control solenoid valve.
|
| STEP 6. Check EGR valve itself. - Check EGR valve itself [Refer to GROUP 17 -
Emission Control
System -
Exhaust Gas Recirculation (EGR) System ].
Q: Is the check result normal?
YES:
Go to Step 7 .
NO:
Replace EGR valve.
|
| STEP 7. MUT-II/III data list - Refer to Data list reference table .
Q: Is the check result normal?
YES:
Go to Step 8 .
NO:
Check oxygen sensor system (Refer to Code No. P0130 ).
|
| STEP 8. Connector check: B-110 and B-111 ignition coil connectors |
|
Q: Is the check result normal?
YES:
Go to Step 9 .
NO:
Repair.
|
| STEP 9. Check ignition coil spark. Q: Is the check result normal?
YES:
Go to Step 14 .
NO:
Go to Step 10 .
|
| STEP 10. Check spark plug. Q: Is the check result normal?
YES:
Go to Step 11 .
NO:
Replace spark plug.
|
| STEP 11. Check spark plug cable itself. - Check spark plug cable itself (Refer to GROUP 16 -
Ignition System -
On-vehicle
Service ).
Q: Is the check result normal?
YES:
Go to Step 12 .
NO:
Replace spark plug cable.
|
| STEP 12. Check ignition coil itself. - Check ignition coil itself (Refer to GROUP 16 -
Ignition System -
On-vehicle
Service ).
Q: Is the check result normal?
YES:
Go to Step 13 .
NO:
Replace ignition coil.
|
| STEP 13. Check harness between terminal No. 2 of ignition coil connector
of each cylinder and body earth. |
|
- Check earthing line for open circuit and damage.
Q: Is the check result normal?
YES:
- Check and repair harness between terminal
No. 3 of ignition coil connector of each cylinder and C-112 engine-A/T-ECU.
- Check signal line for open or short circuit or damage.
NO:
Repair.
|
| STEP 14. Check throttle body (throttle valve portion) for contamination. Q: Is the check result normal?
YES:
Go to Step 15 .
NO:
Clean throttle body (throttle valve portion) (Refer to ).
|
| STEP 15. MUT-II/III actuator test. - Item 12: Waste gate solenoid valve
OK: Operating sound is audible on actuation.
Q: Is the check result normal?
YES:
Go to Step 16 .
NO:
Check waste gate solenoid valve system (Refer to injection procedure 35 ).
|
| STEP 16. Checking turbo charger output pressure. - Check turbo charger output pressure (Refer to ).
Q: Is the check result normal?
YES:
Go to Step 17 .
NO:
Repair.
|
| STEP 17. Checking turbo charger output pressure control system. - Check turbo charger output pressure control system (Refer to ).
Q: Is the check result normal?
YES:
Go to Step 18 .
NO:
Repair.
|
| STEP 18. MUT-II/III actuator test. - Item 09: Fuel pressure control solenoid valve
OK: Operating sound is audible on actuation.
Q: Is the check result normal?
YES:
Go to Step 19 .
NO:
Check fuel pressure control solenoid valve system (Refer to inspection procedure
34 ).
|
| STEP 19. Measure fuel pressure. - Measure fuel pressure (Refer to ).
Q: Is the check result normal?
YES:
Go to Step 20 .
NO:
Repair.
|
| STEP 20. Check compression pressure. - Check compression pressure (Refer to GROUP 11C -
On-vehicle Service ).
Q: Is the check result normal?
YES:
Replace engine-A/T-ECU.
NO:
Repair.
|
)
)