)
)
NOTE:
- The speed adjusting screw is correctly adjusted at the factory and should not be removed.
- If the speed adjusting screw should happen to have been removed, carry out speed adjusting screw adjutment.
)
- Install the throttle position sensor to the throttle body as shown in the illustration.
- Turn the throttle position sensor 90 degrees counterclockwise to set it, and tighten the screws.
)
- Connect an ohmmeter between terminals 2 (output) and 4 (earth), or between terminals 1
(power) and 2 (output).
Then, make sure that the resistance changes smoothly when the throttle valve is slowly moved to the fully open position.