|
Inspection Procedure
10. The Engine stalls when Decelerating
|
|
COMMENT ON TROUBLE SYMPTOM
- Engine stall on deceleration is possibly caused by insufficient air intake,
improper air-fuel ratio due to failed exhaust gas recirculation system or other faults.
|
PROBABLE CAUSE
- Failed idle speed control system
- Failed emission control system
|
| |
| |
| STEP 1. MUT-II/III diagnosis code Q: Diagnosis code set?
YES:
Inspection chart for diagnosis code (Refer to  ).
NO:
Go to Step 2  .
|
| STEP 2. MUT-II/III data list - Refer to Data list reference table .
- Item 14: Throttle position sensor
Q: Is the check result normal?
YES:
Go to Step 3 .
NO:
Check throttle position sensor system (Refer to Code No. 14 ).
|
| STEP 3. MUT-II/III data list - Item 45: Idle speed control servo position
OK: Idle speed control servo drops to 0 -
2 steps at deceleration (engine
at 1,000 r/min or higher).
Q: Is the check result normal?
YES:
Go to Step 4 .
NO:
Check vehicle speed signal system (Refer to Code No. 24 ).
|
| STEP 4. Check EGR control solenoid valve itself. - Check EGR control solenoid valve itself [Refer to GROUP 17 -
Emission
Control System -
Exhaust Gas Recirculation (EGR) System ].
Q: Is the check result normal?
YES:
Go to Step 5 .
NO:
Replace EGR control solenoid valve.
|
| STEP 5. Check EGR valve itself. - Check EGR valve itself [Refer to GROUP 17 -
Emission Control
System -
Exhaust Gas Recirculation (EGR) System ].
Q: Is the check result normal?
YES:
Go to Step 6 .
NO:
Replace EGR valve.
|
| STEP 6. Check throttle body (throttle valve portion) for contamination. Q: Is the check result normal?
YES:
Go to Step 7 .
NO:
Clean throttle body (throttle valve portion) (Refer to ).
|
| STEP 7. Connector check: B-110 and B-111 ignition coil connectors |
|
Q: Is the check result normal?
YES:
Go to Step 8 .
NO:
Repair.
|
| STEP 8. Check ignition coil spark. Q: Is the check result normal?
YES:
Replace engine-A/T-ECU.
NO:
Go to Step 9 .
|
| STEP 9. Check spark plug. Q: Is the check result normal?
YES:
Go to Step 10 .
NO:
Replace spark plug.
|
| STEP 10. Check spark plug cable itself. - Check spark plug cable itself (Refer to GROUP 16 -
Ignition System -
On-vehicle
Service ).
Q: Is the check result normal?
YES:
Go to Step 11 .
NO:
Replace spark plug cable.
|
| STEP 11. Check ignition coil itself. - Check ignition coil itself (Refer to GROUP 16 -
Ignition System -
On-vehicle
Service ).
Q: Is the check result normal?
YES:
Go to Step 12 .
NO:
Replace ignition coil.
|
| STEP 12. Check harness between terminal No. 2 of ignition coil connector
of each cylinder and body earth. |
|
- Check earthing line for open circuit and damage.
Q: Is the check result normal?
YES:
- Check and repair harness between terminal
No. 3 of ignition coil connector of each cylinder and C-112 engine-A/T-ECU.
- Check signal line for open/short circuit and damage.
NO:
Repair.
|
)
)
)