|
Inspection Procedure
11: Engine does not Revolve Up
|
|
COMMENT ON TROUBLE SYMPTOM
- Failure is possibly caused by failed fuel system, ignition system or other
faults.
|
|
| |
| |
| STEP 1. MUT-II/III diagnosis code Q: Diagnosis code set?
YES:
Inspection chart for diagnosis code (Refer to  ).
NO:
Go to Step 2  .
|
| STEP 2. Check timing marks of timing belt. Q: Is the check result normal?
YES:
Go to Step 3 .
NO:
Align match marks.
|
| STEP 3. Connector check: B-110 and B-111 ignition coil connectors |
|
Q: Is the check result normal?
YES:
Go to Step 4 .
NO:
Repair.
|
| STEP 4. Check ignition coil spark. Q: Is the check result normal?
YES:
Go to Step 9 .
NO:
Go to Step 5 .
|
| STEP 5. Check spark plug. Q: Is the check result normal?
YES:
Go to Step 6 .
NO:
Replace spark plug.
|
| STEP 6. Check spark plug cable itself. - Check spark plug cable itself (Refer to GROUP 16 -
Ignition System -
On-vehicle
Service ).
Q: Is the check result normal?
YES:
Go to Step 7 .
NO:
Replace spark plug cable.
|
| STEP 7. Check ignition coil itself. - Check ignition coil itself (Refer to GROUP 16 -
Ignition System -
On-vehicle
Service ).
Q: Is the check result normal?
YES:
Go to Step 8 .
NO:
Replace ignition coil.
|
| STEP 8. Check harness between terminal No. 2 of ignition coil connector
of each cylinder and body earth. |
|
- Check earthing line for open circuit and damage.
Q: Is the check result normal?
YES:
- Check and repair harness between terminal
No. 3 of ignition coil connector of each cylinder and C-112 engine-A/T-ECU.
- Check signal line for open/short circuit and damage.
NO:
Repair.
|
| STEP 9. Measure fuel pressure. - Measure fuel pressure (Refer to ).
Q: Is the check result normal?
YES:
Replace engine-A/T-ECU.
NO:
Repair.
|
)
)
)