|
Inspection Procedure
16: Ignition Timing Offset
|
|
COMMENT ON TROUBLE SYMPTOM
- Failure is possibly caused by failed crank angle sensor, failed camshaft
position sensor, improper installed timing belt or other faults.
|
PROBABLE CAUSE
- Failed crank angle sensor
- Failed camshaft position sensor
- Improperly installed timing belt
|
| |
| |
| STEP 1. MUT-II/III diagnosis code Q: Diagnosis code set?
YES:
Inspection chart for diagnosis code (Refer to  ).
NO:
Go to Step 2  .
|
| STEP 2. Perform output wave pattern measurement of crank angle sensor
and camshaft position sensor (Use oscilloscope). |
|
Crank Angle Sensor
- Use special tool test harness (MD998478) to connect B-28 crank angle sensor connector,
and measure at pick-up harness.
- Selector lever position: P
- Voltage between terminal No. 2 and earth.
Camshaft Position Sensor
- Use special tool test harness (MB991709) to connect B-106 camshaft position sensor
connector, and measure at pick-up harness.
- Selector lever position: P
- Voltage between terminal No. 2 and earth.
OK: Output wave pattern timings of both sensors are the same as the check procedure
(Refer to ) using an oscilloscope.
Q: Is the check result normal?
YES:
Go to Step 3 .
NO:
Go to Step 4 .
|
| STEP 3. Check the trouble symptoms. Q: Does trouble symptom persist?
YES:
Replace engine-A/T-ECU.
NO:
Intermittent malfunction (Refer to GROUP 00 -
How to Use Troubleshooting/Inspection
Service Points ).
|
| STEP 4. Check crank angle sensor and camshaft position sensor mounted
conditions. Q: Is the check result normal?
YES:
Go to Step 5 .
NO:
Repair.
|
| STEP 5. Check timing marks of timing belt. Q: Is the check result normal?
YES:
Go to Step 6 .
NO:
Align timing marks.
|
| STEP 6. Check crank angle sensor vane. Q: Is the check result normal?
YES:
Go to Step 7 .
NO:
Replace crank angle sensor vane.
|
| STEP 7. Check camshaft position sensing cylinder. Q: Is the check result normal?
YES:
Go to Step 8 .
NO:
Replace camshaft position sensing cylinder.
|
| STEP 8. Replace crank angle sensor. - After replacing the crank angle sensor, re-check the trouble symptoms.
Q: Does trouble symptom persist?
YES:
Go to Step 9 .
NO:
Check end.
|
| STEP 9. Replace camshaft position sensor. - After replacing the camshaft position sensor, re-check the trouble symptoms.
Q: Does trouble symptom persist?
YES:
Replace engine-A/T-ECU.
NO:
Intermittent malfunction (Refer to GROUP 00 -
How to Use Troubleshooting/Inspection
Service Points ).
|
)
)