[15] INTAKE AND EXHAUST - - EXHAUST MANIFOLD - INSPECTIONPRINT PAGE / INDEX / PRIOR / NEXT
INSPECTION
Check the following points; replace the part if a problem is found.
Exhaust Manifold Check
  1. Check for damage or cracking of any part.
  1. Using a straight edge and a feeler gauge, check for distortion of the cylinder head installation surface.
    • Standard value: 0.15 mm or less
    • Limit: 0.20 mm
[15] INTAKE AND EXHAUST - - EXHAUST MANIFOLD - INSPECTIONPRINT PAGE / INDEX / PRIOR / NEXT
©2004 Mitsubishi Motors Corporation