REMOVAL AND INSTALLATION

[11D] ENGINE OVERHAUL <4G6-DOHC> - - INLET MANIFOLD - REMOVAL AND INSTALLATION

INLET MANIFOLD

		Removal steps
>>B<<	1.	Manifold differential pressure (MDP) sensor
>>A<<	2.	Inlet manifold stay
	3.	Alternator brace stay
	4.	Inlet manifold
	5.	Inlet manifold gasket
	6.	Detonatoin sensor

INSTALLATION SERVICE POINTS

>>A<< INLET MANIFOLD STAY INSTALLATION

Tighten the bolts to the specified torque 31 ± 3 N·m on both ends after making sure that the stay is in close contact with the bosses on the inlet manifold and cylinder block.

>>B<< MDP SENSOR INSTALLATION

CAUTION

Install the MDP sensor carefully not to give it a shock.

Do not use the sensor that has fallen to floor or any other surface.

[11D] ENGINE OVERHAUL <4G6-DOHC> - - INLET MANIFOLD - REMOVAL AND INSTALLATION

PRINT PAGE / INDEX / PRIOR / NEXT