)
| Removal steps |
|||
|---|---|---|---|
| 1. |
Oil level gauge |
||
| 2. |
Oil level gauge guide |
||
| 3. |
O-ring |
||
| 4. |
Auto tensioner |
||
| 5. |
Crankshaft pulley |
||
| 6. |
Water pump pulley |
||
| 7. |
Idler pulley |
||
| 8. |
Connector bracket |
||
| 9. |
Alternator |
||
| 10. |
Ignition coil |
||
<<A>> |
>>C<< |
11. |
Spark plug |
| 12. |
Connector bracket |
||
| 13. |
Camshaft position sensor |
||
| 14. |
O-ring |
||
| >>B<< |
15. |
Camshaft position sensor support |
|
| <<B>> |
>>A<< |
16. |
Camshaft position sensing cylinder |
)
Using special tool Spark plug wrench (MB991398), removal the spark plug.
)
- Using special tool Fly wheel stopper (MD998781), hold the drive plate.
- Removal the camshaft position sensing cylinder.
- Using special tool Fly wheel stopper (MD998781), hold the drive plate.
- Tighten the camshaft position sensing cylinder to the specified torque.
Tightening torque: 22 ±
4 N·m
)
- Remove completely the FIPG remaining on the camshaft position sensor support and cylinder head.
- Apply a 3 ± 1 mm diameter bead of FIPG to the indicated surface of the camshaft position sensor support.
Specified sealant:
- Mitsubishi Genuine Part No.MD970389 or equivalent
Using special tool Spark plug wrench (MB991398), tighten the spark plug to the specified
torque.
Tightening torque: 25 ±
5 N·m