[11B] ENGINE OVERHAUL <4G6-SOHC> - - ALTERNATOR AND IGNITION SYSTEM - REMOVAL AND INSTALLATIONPRINT PAGE / INDEX / PRIOR / NEXT
ALTERNATOR AND IGNITION SYSTEM
REMOVAL AND INSTALLATION
   



Removal steps


1.
 Auto tensioner


2.
 Water pump pulley


3.
 Alternator brace


4.
 Alternator


5.
 Crankshaft pulley


6.
 Spark plug cable


7.
 Ignition coil


8.
 Spark plug
    9.
 Camshaft position sensor

>>A<<
 10.
 Camshaft position sensor support
    11.
 Camshaft position sensing cylinder

INSTALLATION SERVICE POINTS
>>A<< CAMSHAFT POSITION SENSOR SUPPORT INSTALLATION
   
Apply a 3mm diameter bead of form-in-place gasket (FIPG) to the gasket surface as shown in the drawing.
Specified sealant:
  • Mitsubishi Genuine Part No.MD970389 or equivalent
[11B] ENGINE OVERHAUL <4G6-SOHC> - - ALTERNATOR AND IGNITION SYSTEM - REMOVAL AND INSTALLATIONPRINT PAGE / INDEX / PRIOR / NEXT
©2004 Mitsubishi Motors Corporation