)
| Disassembly steps |
|||
|---|---|---|---|
| 1. |
Licence plate garnish |
||
| 2. |
Centre cover |
||
<<A>> |
>>A<< |
3. |
Rivets A |
| <<A>> |
>>A<< |
4. |
Rivets B |
| 5. |
Front bumper side plate |
||
| 6. |
Front bumper centre reinforcement |
||
| 7. |
Oil cooler duct |
||
| 8. |
Air intake bezel (Vehicles without fog lamp) |
||
| 9. |
Fog lamp bezel |
||
| 10. |
Fog lamp assembly |
||
| 11. |
Front bumper core |
||
| 12. |
Three-diamond mark |
||
| 13. |
Front bumper extension <SPORT GEAR, GLS, GLX, XLS> |
||
| 14. |
Front bumper face |
DISASSEMBLY SERVICE POINT
)
Use a drill (&phis;4.0 mm) to make a hole in the rivet to break it, and then remove the rivet.
REASSEMBLY SERVICE POINT
)
Use recommended tool shown in the illustration to connect the rivet by the following procedure.
- Insert rivets A and rivets B into the front bumper face and front bumper upper plate.
- Place the recommended tool over section C of rivet.
- While pushing the flange surface of the rivet with the recommended tool, press the handle of the tool.
- The thin part of section C of the rivet will break and the rivet will then be attached.