)
| Disassembly steps |
|||
|---|---|---|---|
| 1. |
Licence plate bracket |
||
| 2. |
Air guide panel |
||
| 3. |
Air guide duct |
||
| 4. |
Fog lamp |
||
| 5. |
Front bumper reinforcement |
||
| 6. |
Front bumper grille |
||
<<A>> |
>>A<< |
7. |
Rivets A |
| <<A>> |
>>A<< |
8. |
Rivets B |
| 9. |
Front bumper upper plate |
||
| 10. |
Front bumper face |
DISASSEMBLY SERVICE POINT
)
Use a drill (&phis;4.0 mm) to make a hole in the rivet to break it, and then remove the rivet.
REASSEMBLY SERVICE POINT
)
Use recommended tool shown in the illustration to connect the rivet by the following procedure.
- Insert rivets A and rivets B into the front bumper face and front bumper upper plate.
- Place the recommended tool over section C of rivet.
- While pushing the flange surface of the rivet with the recommended tool, press the handle of the tool.
- The thin part of section C of the rivet will break and the rivet will then be attached.