)
| Disassembly steps |
|||
|---|---|---|---|
| 1. |
Side cover |
||
| 2. |
Muffler cover |
||
| 3. |
Rear bumper cover |
||
<<A>> |
>>A<< |
4. |
Rivets |
| 5. |
Rear bumper side plate |
||
| 6. |
Rear bumper harness |
||
| 7. |
Rear bumper reinforcement |
||
| 8. |
Licence plate lamp assembly |
||
| 9. |
Reflector |
||
| 10. |
Licence plate bracket |
||
| 11. |
Rear bumper extension <SPORT GEAR, GLS, XLS> |
||
| 12. |
Rear bumper face |
DISASSEMBLY SERVICE POINT
)
Use a drill (&phis;4.0 mm) to make a hole in the rivet to break it, and then remove the rivet.
REASSEMBLY SERVICE POINT
)
Use recommended tool shown in the illustration to connect the rivet by the following procedure.
- Insert the rivet into the base material (rear bumper face, rear bumper side plate).
- Place the recommended tool over section A of rivet.
- While pushing the flange surface of the rivet with the recommended tool, press the handle of the tool.
- The thin part of section A of the rivet will break and the rivet will then be attached.