WINDSHIELD WASHER MOTOR CHECK
)
- Remove the washer tank assembly with the washer hose attached. Then fill the washer tank with water.
- Check to see that the water is vigorously sprayed when connecting the positive battery terminal to terminal number 2 and terminal number 1 to the negative battery terminal.
WINDSHIELD WASHER FLUID EJECTION CHECK
Move the nozzle to adjust the position so that the spray is in the area shown in the illustration.)
)
WINDSHIELD WASHER SWITCH CHECK <L.H. DRIVE VEHICLE>
)
Check continuity between the switch terminals.
| Switch position |
Tester connection |
Specified condition |
|---|---|---|
| OFF |
6 -
7 |
Open circuit |
| Windshield washer switch |
6 -
7 |
Less than 2 ohms |
<R.H. DRIVE VEHICLE>
NOTE: The windshield washer switch is integrated in the column-ECU, so can not be checked as
an individual part. However, its operation can be checked by the input signal check.
- Not using SWS monitor: Refer to GROUP 54B, Troubleshooting
or
GROUP 54D, Troubleshooting .
- Using SWS monitor: Refer to GROUP 54C, Troubleshooting or
GROUP 54E, Troubleshooting .