Pre-removal and Post-installation Operation
Washer Tank Assembly and Rear Washer Motor Removal and Installation (Refer to <2000>  or <2400> ). |
)
| Wiper blade assembly removal steps |
|||
|---|---|---|---|
| 1. |
Wiper blade assembly |
||
>>B<< |
2. |
Wiper blade |
|
| Rear wiper motor removal steps |
|||
| >>A<< |
3. |
Wiper arm and blade assembly |
|
| • |
Tailgate lower trim (Refer to GROUP 52A, Tailgate trim ). |
||
| • |
Tailgate waterproof film (Refer to GROUP 42, Tailgate ). |
||
| 4. |
Rear wiper motor assembly |
||
| Rear washer nozzle removal steps |
|||
| • |
High-mounted stop lamp assembly (Refer to GROUP 54A, High-mounted stop
lamp ). |
||
| 5. |
Rear washer nozzle |
||
| Washer hose removal steps |
|||
| • |
Cowl side trim, front scuff plate, centre pillar trim lower, rear
scuff plate, rear pillar trim and rear shelf trim (Refer to GROUP 52A, Trims ). |
||
| • |
Tailgate lower trim, tailgate side trim, tailgate upper trim (Refer
to GROUP 52A, Tailgate trim ). |
||
| • |
High-mounted stop lamp assembly (Refer to GROUP 54A, High-mounted stop
lamp ). |
||
| 6. |
Rear washer hose |
NOTE: For removal and installation of the wiper and washer switch, refer to GROUP 54A, Column
switch .
.INSTALLATION SERVICE POINTS
)
Before installing the rear wiper arm and blade assembly, operate the rear wiper motor
so that the motor stops at the predetermined park position. Install the rear wipe arm and blade
assembly and adjust the rear wiper blade position so that the blade end stops at the predetermined
position (standard position).
Standard value (A): 30 ±
5 mm
)
CAUTION