)
)
| Removal steps |
|||
|---|---|---|---|
<<A>> |
>>A<< |
1. |
Side sill garnish |
| >>B<< |
2. |
Side sill garnish protect film |
)
REMOVAL SERVICE POINTS
)
- Attach protection tape all the way along the edges of the double-sided tape which is still adhering to the body.
)
- Scrape off the double-sided tape with a resin spatula as possible.
- Peel off the protection tape.
- Wipe the body surface and clean it with a rag moistened with isopropyl alcohol.
<Remove double-sided tape remaining on SIDE SILL GARNISH and adhere double-sided tape (when re-using SIDE SILL GARNISH)>
)
- Scrape off the double-sided tape on the side sill garnish with a resin spatula as possible.
- Wipe the side sill garnish surface and clean it with a rag moistened with isopropyl alcohol.
- Remove only a small portion of the residual adhesive.
- Adhere the double-sided tape as specified on the side sill garnish. (Refer to double-sided tape adherence location.)
INSTALLATION SERVICE POINTS
)
- Tear off the double-sided tape backing paper.
NOTE: If you attach the adhesive tape to the edge of the backing paper, it will be easy to tear off.
- Install the side sill garnish.
NOTE: If the double-sided tape is difficult to affix in cold temperature, etc., warm the bonding surfaces of the body and side sill garnish to about 40 -
60°C before affixing the tape.
- Firmly press in the side sill garnish.
CAUTION)
- The ambient temperature should be 20 to
38°C . Ensure that the working area is clean. - If ambient temperature is less than
20°C , heat the protect film and application surface to a temperature of 20 to30°C . - Be careful that air bubbles are not formed under the protect film.
- Installation procedure
- Wipe the protect film application surface and clean it with a rag moistened with isopropyl alcohol.
- Remove backing paper from the protect film, and apply the film to the specified position.