Pre-removal and Post-installation Operation
|
)
| Removal steps |
|||
|---|---|---|---|
| 1. |
Fuel pressure control solenoid valve connector |
||
| 2. |
Waste gate solenoid valve connector |
||
| 3. |
Engine coolant temperature gauge unit connector |
||
| 4. |
Engine coolant temperature sensor connector |
||
| 5. |
Control wiring harness connection |
||
| 6. |
Harness bracket |
||
<<A>> |
>>B<< |
7. |
Radiator lower hose connection |
| 8. |
Water inlet fitting |
||
| >>A<< |
9. |
Thermostat |
REMOVAL SERVICE POINT
)
Make mating marks on the radiator hose and the hose clamp. Disconnect the radiator hose.
INSTALLATION SERVICE POINTS
CAUTION)
Install the thermostat so that the jiggle valve is facing straight up. Be careful not
to fold or scratch the rubber ring.
)
- Insert each hose as far as the projection of the water inlet fitting.
- Align the mating marks on the radiator hose and hose clamp, and then connect the radiator hose.