[14] ENGINE COOLING - - THERMOSTAT - REMOVAL AND INSTALLATION <4G69-SOHC>PRINT PAGE / INDEX / PRIOR / NEXT
REMOVAL AND INSTALLATION <4G69-SOHC>
Pre-removal and Post-installation Operation
  • Engine Coolant Draining and Refilling (Refer to ).
  • Air Cleaner Removal and Installation (Refer to GROUP 15, Air Cleaner ).
  • Battery Removal and Installation

   



Removal steps
<<A>>
 >>B<<
 1.
 Radiator lower hose connection


2.
 Control wiring harness connection


3.
 Control wiring harness connection bracket


4.
 Water inlet fitting

>>A<<
 5.
 Thermostat

REMOVAL SERVICE POINT
<<A>> RADIATOR LOWER HOSE DISCONNECTION
   
Make mating marks on the radiator hose and the hose clamp. Disconnect the radiator hose.
INSTALLATION SERVICE POINTS
>>A<< THERMOSTAT INSTALLATION
 CAUTION
 Make absolutely sure that no oil adheres to the rubber ring of the thermostat. Also do not fold or scratch the rubber ring during installation.
   
Install the thermostat so that the jiggle valve is facing straight up. Be careful not to fold or scratch the rubber ring.
>>B<< RADIATOR LOWER HOSE CONNECTION
       
    1. Insert each hose as far as the projection of the water inlet fitting.
    1. Align the mating marks on the radiator hose and hose clamp, and then connect the radiator hose.
    [14] ENGINE COOLING - - THERMOSTAT - REMOVAL AND INSTALLATION <4G69-SOHC>PRINT PAGE / INDEX / PRIOR / NEXT
    ©2004 Mitsubishi Motors Corporation