Pre-removal and Post-installation Operation
|
)
| Removal steps |
|||
|---|---|---|---|
| 1. |
Oxygen sensor |
||
<<A>> |
>>C<< |
2. |
Radiator upper hose connection |
| 3. |
Radiator clamp |
||
| >>B<< |
4. |
Water outlet fitting |
|
| 5. |
Water temperature gauge unit connector |
||
| 6. |
Water feed hose |
||
| 7. |
Heater hose connection |
||
| >>B<< |
8. |
Thermostat case assembly |
|
| >>A<< |
9. |
O-ring |
|
| 10. |
Heater hose connection |
||
| 11. |
Water return hose |
||
| 12. |
Harness clamp |
||
| 13. |
Water inlet pipe assembly |
||
| >>A<< |
14. |
O-ring |
REMOVAL SERVICE POINT
)
After making mating marks on the radiator hose and hose clamp, disconnect the radiator
hose.
INSTALLATION SERVICE POINTS
)
CAUTION>>B<<
THERMOSTAT CASE ASSEMBLY/WATER OUTLET FITTING
INSTALLATION
- Use a gasket scraper or wire brush to completely eliminate all gasket material on the gasket mounting surface.
- Apply a bead of the specified sealant.
Specified Sealant: MITSUBISHI GENUINE PART No. MD970389 or equivalent
- With the sealant still wet (within 15 minutes after the sealant is applied), install the thermostat case or water outlet fitting. Do not apply the sealant in an area more than the required.
)
- Insert each hose as far as the projection of the water outlet fitting.
- Align the mating marks on the radiator hose and hose clamp, and then connect the radiator hose.