INSPECTION PROCEDURE E-2: Keyless entry hazard warning lamp answerback function or the room lamp answerback function does not work normally.

[54D] SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR <Except for Hong Kong spec.> - - SYMPTOM PROCEDURES - KEYLESS ENTRY SYSTEM - INSPECTION PROCEDURE E-2: Keyless entry hazard warning lamp answerback function or the room lamp answerback function does not work normally.

PRINT PAGE / INDEX / PRIOR / NEXT



INSPECTION PROCEDURE E-2: Keyless entry hazard warning lamp answerback function or the room lamp answerback function does not work normally.

	CAUTION Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.

	COMMENTS ON TROUBLE SYMPTOM If the hazard warning lamp and the room lamp work normally, the ETACS-ECU may be defective. Alternatively, it is possible that the keyless entry hazard warning lamp answerback function was disabled by the adjustment function.
	POSSIBLE CAUSES Defective turn-signal lamp Malfunction of the room lamp Malfunction of the ETACS-ECU Damaged harness wires and connectors
	DIAGNOSIS PROCEDURE

	Step 1. Check the adjustment function. Check that the keyless entry hazard warning lamp answerback function has been enabled by using the adjustment function. Q: Is the check result normal? YES: Go to Step 2 . NO: Enable the keyless entry hazard warning lamp answerback function by using the adjustment function. (Refer to ).
	Step 2. Check the operation of the hazard warning lamp. Check that the hazard warning lamps illuminate normally. Q: Is the check result normal? YES: Go to Step 3 . NO: Refer to Inspection Procedure M-2 "The hazard warning lamps do not illuminate ".
	Step 3. Check the operation of the room lamps. Check that the room lamps illuminate normally. Q: Is the check result normal? YES: Go to Step 4 . NO: Refer to Inspection Procedure O-2 "The front or rear room lamp does not illuminate/extinguish ."
	Step 4. Retest the system. Check that the keyless entry hazard warning lamp answerback function or the room lamp answerback function work normally. Q: Is the check result normal? YES: The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ). NO: Replace the ETACS-ECU.

PRINT PAGE / INDEX / PRIOR / NEXT