INSPECTION PROCEDURE F-2: Any of the sunroof switch positions is defective.

[54D] SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR <Except for Hong Kong spec.> - - SYMPTOM PROCEDURES - SUNROOF - INSPECTION PROCEDURE F-2: Any of the sunroof switch positions is defective.

PRINT PAGE / INDEX / PRIOR / NEXT


INSPECTION PROCEDURE F-2: Any of the sunroof switch positions is defective.
	CAUTION Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.

	COMMENTS ON TROUBLE SYMPTOM If any of the sunroof switch positions is defective, the communication line between the sunroof switch and the sunroof motor assembly (sunroof-ECU) may be defective.
	POSSIBLE CAUSES Malfunction of the sunroof switch Malfunction of the sunroof motor assembly (sunroof-ECU) Damaged harness wires and connectors
	DIAGNOSIS PROCEDURE

	Step 1. Connector check: D-06 sunroof switch connector Q: Is the check result normal? YES: Go to Step 2 . NO: Repair the connector.
	Step 2. Check the sunroof switch. Refer to GROUP 42 - Sunroof . Q: Is the check result normal? YES: Go to Step 3. NO: Replace the sunroof switch.
	Step 3. Connector check: D-09 sunroof motor assembly connector Q: Is the check result normal? YES: Go to Step 4 . NO: Repair the connector.
	Step 4. Check the wiring harness between D-09 sunroof motor assembly connector terminal No.6, 7 and 8 and D-06 sunroof switch connector terminal No.6, 3 and 5. Check the communication line for open circuit. Q: Is the check result normal? YES: Replace the sunroof motor assembly. NO: Repair the wiring harness.

[54D] SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR <Except for Hong Kong spec.> - - SYMPTOM PROCEDURES - SUNROOF - INSPECTION PROCEDURE F-2: Any of the sunroof switch positions is defective.

PRINT PAGE / INDEX / PRIOR / NEXT