CAUTION
Before connecting or disconnecting the MUT-II/III, turn the ignition switch to the "LOCK" (OFF) position.
  1. The input signals (signals other than communication line signals), which are compatible with the SWS monitor by using the MUT-II/III or voltmeter, can be confirmed by the Pulse Check.
  2. NOTE: If a problem is found in the "Pulse Check", refer to the Problems during Input Signal Check <Service data, function diagnosis or pulse check> (Refer to ).
  1. Use the MUT-II/III or voltmeter to check the following input signals.
SWITCHES WHICH ARE APPLICABLE TO INPUT SIGNAL CHECK, AND THEIR CHECK CONDITIONS
Input signal
Requirements for sounding buzzer
Key reminder switch <vehicles with keyless entry system>
When the inserted ignition key is pulled out.
Hazard warning lamp switch
When the switch is turned from off to on.
Front fog lamp switch
Rear fog lamp switch
All of the door switches
A door is opened when all the doors are closed.
Driver's door lock actuator
When the driver's key cylinder or inside lock knob is unlocked or locked.
Vehicle speed signal (engine-A/T-ECU) <Except vehicles for
GCC>
When the vehicle speed has reached 10 km/h or more.
Keyless entry transmitter
Switches
When the switch is turned from off to on.
Interior lamp loaded signal
When a load is applied through multi-purpose fuse No.22.
©2004 Mitsubishi Motors Corporation