INSPECTION PROCEDURE E-4: The timer lock function does not work after the doors have been unlocked by the keyless entry system.

[54E] SMART WIRING SYSTEM (SWS) USING SWS MONITOR <Except for Hong Kong spec.> - - SYMPTOM PROCEDURES - KEYLESS ENTRY SYSTEM - INSPECTION PROCEDURE E-4: The timer lock function does not work after the doors have been unlocked by the keyless entry system.

PRINT PAGE / INDEX / PRIOR / NEXT



INSPECTION PROCEDURE E-4: The timer lock function does not work after the doors have been unlocked by the keyless entry system.

	CAUTION Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.

	COMMENT ON TROUBLE SYMPTOM If the keyless entry timer lock does not work normally, the input signal circuit(s) to the keyless entry transmitter or the ETACS-ECU may be defective.
	POSSIBLE CAUSES Malfunction of the keyless entry transmitter Malfunction of the ETACS-ECU Damaged harness wires and connectors
	DIAGNOSIS PROCEDURE

	Step 1. Check the operation of the keyless entry system. Check that the keyless entry system works normally. Q: Is the check result normal? YES: Go to Step 2 . NO: Refer to Inspection Procedure E-1 "Keyless entry system does not work ."
	Step 2. Retest the system. Check that the timer lock works normally. Q: Is the check result normal? YES: The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ). NO: Replace the ETACS-ECU.

PRINT PAGE / INDEX / PRIOR / NEXT