|
| |
INSPECTION PROCEDURE C-5: The impact detection door unlock function does not function. |
|
|
|  CAUTION
Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.
|
| |
| COMMENTS ON TROUBLE SYMPTOM
If the impact detection door unlock function does not work normally, the input signal circuit from the impact detection sensor, the SRS-ECU or the ETACS-ECU may be defective.
|
| POSSIBLE CAUSES
- Malfunction of the SRS-ECU
- Malfunction of the ETACS-ECU
- Damaged harness wires and connectors
|
| |
| |
| Step 1. MUT-II/III diagnosis code
Check that the SRS-ECU sets a diagnosis code.
Q: Is the diagnosis code set?
YES:
Refer to GROUP 52B -
Troubleshooting  .
NO:
Go to Step 2  .
|
| Step 2. ECU check by using the SWS monitor
Check that the power supply and earth lines to the ETACS-ECU and the SWS communication lines are normal.
ECU TO BE CHECKED
OK: "OK" is displayed on the "ETACS ECU" menu.
Q: Is the check result normal?
YES:
Go to Step 3 .
NO:
Refer to Inspection Procedure A-3 "Communication with ETACS-ECU is not possible ."
|
| Step 3. Connector check: C-115 SRS-ECU connector Q: Is the check result normal?
YES:
Go to Step 4 .
NO:
Repair the defective connector.
|
| Step 4. Measure the resistance at the C-115 SRS-ECU connector. - Disconnect the connector, and measure at the wiring harness side.
- Resistance between C-115 SRS-ECU connector terminal No.15 and body earth
OK: 2 Ω
or less
Q: Is the check result normal?
YES:
Go to Step 6 .
NO:
Go to Step 5 .
|
| Step 5. Check the wiring harness between C-115 SRS-ECU connector terminal No.15 and body earth. - Check the earth line for open or short circuit.
Q: Is the check result normal?
YES:
The trouble can be an intermittent malfunction (Refer to GROUP 00 -
How to Cope with Intermittent Malfunction ).
NO:
Repair the wiring harness.
|
| Step 6. Connector check: C-220 ETACS-ECU connector Q: Is the check result normal?
YES:
Go to Step 7 .
NO:
Repair the defective connector.
|
| Step 7. Check the wiring harness between C-115 SRS-ECU connector terminal No.14 and C-220 ETACS-ECU connector terminal No.29. - Check the power supply line for open or short circuit.
Q: Is the check result normal?
YES:
Go to Step 8 .
NO:
Repair the wiring harness.
|
| Step 8. Retest the system.
Check that the impact detection door unlock function works normally.
Q: Is the check result normal?
YES:
The trouble can be an intermittent malfunction (Refer to GROUP 00 -
How to Cope with Intermittent Malfunction ).
NO:
Replace the ETACS-ECU.
|