[54B] SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR <Hong Kong spec.> - - DIAGNOSTIC TROUBLE CODE PROCEDURES - Diagnosis code 11: Trouble related to the ETACS-ECUPRINT PAGE / INDEX / PRIOR / NEXT
DIAGNOSTIC TROUBLE CODE PROCEDURES
Diagnosis code 11: Trouble related to the ETACS-ECU
COMMENTS ON TROUBLE SYMPTOM
The ETACS-ECU monitors the data, which the ECU itself sends. If errors occur consecutively 15 times (for 0.6 seconds), a diagnosis code will be set. Then, if the data does not contain any errors consecutively 15 times (for 0.6 seconds), the ECU will stop sending the diagnosis code.
POSSIBLE CAUSES
  • Malfunction of the ETACS-ECU
DIAGNOSIS PROCEDURE
Check whether the diagnosis code is reset.
  1. Erase the diagnosis code.
  1. Again check that diagnosis code No.11 is set.
Q: Is diagnosis code No.11 set?
YES:  Replace the ETACS-ECU.
NO:  The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
[54B] SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR <Hong Kong spec.> - - DIAGNOSTIC TROUBLE CODE PROCEDURES - Diagnosis code 11: Trouble related to the ETACS-ECUPRINT PAGE / INDEX / PRIOR / NEXT
©2004 Mitsubishi Motors Corporation