[54B] SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR <Hong Kong spec.> - - SYMPTOM PROCEDURES - SECURITY-ALARM SYSTEM - INSPECTION PROCEDURE O-2: The interior alarm does not work normally while the security alarm is triggered.PRINT PAGE / INDEX / PRIOR / NEXT
INSPECTION PROCEDURE O-2: The interior alarm does not work normally while the security alarm is triggered.
 CAUTION
 Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.
COMMENTS ON TROUBLE SYMPTOM
If the interior alarm does not work normally, the input signal circuits to the components below or the ETACS-ECU may be defective.
  • Hood switch
  • All of the door switches
In addition, it is possible that the security alarm function has been disabled by using the adjustment function.
POSSIBLE CAUSES
  • Malfunction of the hood switch
  • All the door switches are defective.
  • Malfunction of the ETACS-ECU
  • Damaged harness wires and connectors
DIAGNOSIS PROCEDURE
Step 1. Check the adjustment function.
Check that the security alarm function has been enabled by using the adjustment function.
Q: Is the check result normal?
YES:  Go to Step 2.
NO:  Enable the security alarm function using the adjustment function. (Refer to .)
Step 2. Check the power supply circuit.
When the ignition switch is turned to the LOCK (OFF) position, check if the hazard warning lamps illuminate.
Q: Is the check result normal?
YES:  Go to Step 3.
NO:  Refer to inspection procedure A-2 "Check the battery power supply circuit to the ETACS-ECU ."
Step 3. Pulse check
Check the input signals which are related to the security alarm.
System switch
 Check conditions
All of the door switches
 A door is opened when all the doors are closed
Hood switch
 When the switch is turned from off to on

OK: The MUT-II/III sounds or the voltmeter needle fluctuates.
Q: Are the check result normal?
All the signals are received normally.:  Go to Step 4.
All the door switch signals are not received.:  Refer to inspection procedure P-13 "All the door switch signals are not received ."
The hood switch signal is not received.:  Refer to inspection procedure P-20 "The hood switch signal is not received. ."
Step 4. Retest the system.
Check that the security alarm works normally.
Q: Is the check result normal?
YES:  The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
NO:  Replace the ETACS-ECU.
[54B] SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR <Hong Kong spec.> - - SYMPTOM PROCEDURES - SECURITY-ALARM SYSTEM - INSPECTION PROCEDURE O-2: The interior alarm does not work normally while the security alarm is triggered.PRINT PAGE / INDEX / PRIOR / NEXT
©2004 Mitsubishi Motors Corporation