[54C] SMART WIRING SYSTEM (SWS) USING SWS MONITOR <Hong Kong spec.> - - SYMPTOM PROCEDURES - HEADLAMP AND TAIL LAMP - INSPECTION PROCEDURE K-7: The auto lamp function does not work normally.PRINT PAGE / INDEX / PRIOR / NEXT
INSPECTION PROCEDURE K-7: The auto lamp function does not work normally.
 CAUTION
 Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.
COMMENTS ON TROUBLE SYMPTOM
If auto lamp function does not work normally, the above input signal circuit(s) or the ETACS-ECU may be defective.
POSSIBLE CAUSES
  • Malfunction of the ETACS-ECU
  • Malfunction of the front-ECU
  • Damaged harness wires and connectors
DIAGNOSIS PROCEDURE
Step 1. Check that the taillights and headlamps operate.
Check that the tail lights and headlamps illuminate normally.
Q: Is the check result normal?
YES:  Go to Step 2.
NO:  Check the taillights and the headlamps (Refer to trouble symptom chart ).
Step 2. SWS monitor data list.
Check the ETACS-ECU signals, which are related to the auto lamp function.
<Selected item> ETACS ECU
  • Ignition switch: ON
Item No.
 Item name
 Normal conditions
Item 30
 IG SW(IG1)
 ON

OK: Normal condition is displayed.
Q: Is the check result normal?
YES:  Go to Step 3.
NO:  Refer to inspection procedure P-2 "The ignition switch (IG1) signal is not received ."
Step 3. ETACS ANALOG data by using the SWS monitor.
Check the ETACS-ECU signals, which are related to the auto lamp function.
  • Vary the light intensity to the photo sensor.
Item No.
 Item name
 Normal conditions
Item 01
 Photo sensor voltage
 The voltage changes within a range of 0.68 to 3.8 V.

OK: Normal condition is displayed.
Q: Is the check result normal?
YES:  Go to Step 4.
NO:  Refer to Inspection Procedure P-21 "No photo sensor signal is received ."
Step 4. ETACS ANALOG data by using the SWS monitor.
Check the ETACS-ECU input signals, which are related to the auto lamp function.
  • Set the simulated vehicle speed at approximately 10km/h.
Item No.
 Item name
 Normal condition
Item 03
 SPEED SENSOR
 8 to 10 km/h

OK: Normal condition is displayed.
Q: Is the check result normal?
YES:  Go to Step 5.
NO:  Refer to inspection procedure P-15 "The vehicle speed signal is not received ."
Step 5. Retest the system.
Check that the auto lamp function works normally.
Q: Is the check result normal?
YES:  The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
NO:  Replace the ETACS-ECU.
[54C] SMART WIRING SYSTEM (SWS) USING SWS MONITOR <Hong Kong spec.> - - SYMPTOM PROCEDURES - HEADLAMP AND TAIL LAMP - INSPECTION PROCEDURE K-7: The auto lamp function does not work normally.PRINT PAGE / INDEX / PRIOR / NEXT
©2004 Mitsubishi Motors Corporation