PULSE CHECK PROCEDURE
- The input signals (signals other than communication line signals), which are compatible with the SWS monitor by using the MUT-II/III or voltmeter, can be confirmed by the Pulse Check (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points).
- Use the MUT-II/III or voltmeter to check the following input signals.
NOTE: If a problem is found in the "Pulse check", refer to the Problems during Input Signal
Check <Service data, function diagnosis or pulse check>
(Refer to 
).
).Switches and their conditions, which are applicable for Pulse Check
| Input signals |
Requirements for sounding buzzer |
|
|---|---|---|
| INTERIOR LAMP LOADED SIGNAL |
When a load is applied through multi-purpose fuse No.18 |
|