SPECIAL TOOLS
| Tool |
Number |
Name |
Use |
|---|---|---|---|
)
|
MB990767 |
Front hub and flange yoke holder |
Fixing of the hub |
)
|
MB991618 |
Hub bolt remover |
Removal of the hub bolt |
)
|
MB991897 |
Ball joint remover |
Knuckle and tie rod end ball joint disconnection NOTE: Steering linkage puller (MB990635 or MB991113)is also used to disconnect knuckle and tie
rod end ball joint.
|
)
|
MB990241 A: MB990242 B: MB990244 |
Axle shaft puller A: Puller shaft B: Puller bar |
Removal of the drive shaft |
)
|
MB991354 |
Puller body |
|
)
|
MB991056 or MB991355 |
Knuckle arm bridge |
|
)
|
MB991721 |
Sliding hammer |
Removal of the output shaft <4WD> |
)
|
A: MB991017 B: MB990998 C: MB991000 |
A, B: Front hub remover and installer C: Spacer |
NOTE: MB991000, which belongs to MB990998, should be used as a spacer.
|
)
|
MB990685 |
Torque wrench |
Measurement of hub starting torque |
)
|
MB990326 |
Preload socket |
|
)
|
MB990810 |
Side bearing puller |
|
)
|
MB991172 |
Inner shaft installer base |
Press-fitting of the inner shaft |
)
|
MB991248 or MB998801 |
Inner shaft remover |
Removal of the inner shaft |
)
|
MB991460 |
Plug |
Prevention of transmission fluid drain and of entry of foreign objects |
)
|
MB991561 |
Boot band crimping tool |
BJ boot (resin boot) band installation |
)
|
MB990925 |
Bearing and oil seal installer set |
|
)
|
MB990890 |
Rear suspension bushing base |
|
)
|
MB990883 |
Rear suspension bushing arbor |
Installation of the wheel bearing |
| Tool |
Type |
Tool number |
O D mm |
|---|---|---|---|
)
|
A |
MB990926 |
39.0 |
| MB990927 |
45.0 |
||
| MB990928 |
49.5 |
||
| MB990929 |
51.0 |
||
| MB990930 |
54.0 |
||
| MB990931 |
57.0 |
||
| MB990932 |
61.0 |
||
| MB990933 |
63.5 |
||
| MB990934 |
67.5 |
||
| MB990935 |
71.5 |
||
| MB990936 |
75.5 |
||
| MB990937 |
79.0 |
||
| B |
MB990938 |
- |
|
| C |
MB990939 |
- |