[23A] AUTOMATIC TRANSMISSION (FF) - - ON-VEHICLE SERVICE - LINE PRESSURE ADJUSTMENTPRINT PAGE / INDEX / PRIOR / NEXT
LINE PRESSURE ADJUSTMENT
  1. Drain the transmission fluid.
    2. NOTE: The hydraulic pressure test must be performed before attempting any adjustments.
  1. Remove the valve body cover.
       
    1. Turn the adjusting screw shown in the illustration to adjust the line pressure to the standard value. The pressure increases when the screw is turned anti-clockwise.
      2. NOTE: When adjusting the line pressure, adjust to the middle of the standard value range.
      Standard value: 1.01 - 1.05 MPa
      (Change in pressure for a single full of the adjusting screw: 0.035 MPa)
    1. Install the valve body cover, and then pour in the specified amount of A/T fluid.
    1. Repeat the hydraulic pressure test. (Refer to .) Readjust the line pressure if necessary.
    [23A] AUTOMATIC TRANSMISSION (FF) - - ON-VEHICLE SERVICE - LINE PRESSURE ADJUSTMENTPRINT PAGE / INDEX / PRIOR / NEXT
    ©2004 Mitsubishi Motors Corporation