)
- Remove the A/T fluid temperature sensor.
)
- Measure the resistance between A/T control solenoid valve assembly connector terminals 1 and 2.
Standard value:
| A/T fluid temperature ( |
Resistance value (Ω) |
|---|---|
| 0 |
16.7 -
20.5 |
| 20 |
7.3 -
8.9 |
| 40 |
3.4 -
4.2 |
| 60 |
1.9 -
2.2 |
| 80 |
1.0 -
1.2 |
| 100 |
0.57 -
0.69 |
NOTE: The N range indicator <Vehicles for Hong Kong spec.>
or A/T fluid temperature warning lamp <Except for Hong Kong spec.>
on the combination meter flashes when the temperature reaches approximately 125 °C or higher and then stops flashing when the temperature drops below approximately 115°C .
- If the A/T fluid temperature sensor resistance and the temperature when the N range indicator is flashing or switched off are outside the standard value ranges, replace the A/T fluid temperature sensor.