WARNINGPre-removal and Post-installation Operation
|
)
| Transmission control cable assembly removal steps |
|||
|---|---|---|---|
| • |
Air cleaner assembly (Refer to GROUP 15 - Air cleaner  <4G63-SOHC,
4G64>, GROUP 15 - Air cleaner <4G63-DOHC>, GROUP
15 - Air cleaner <4G69>.) |
||
| • |
Battery and battery tray |
||
>>B<< |
1. |
Transmission control cable assembly connection (transmission side) |
|
| >>A<< |
2. |
Shift lock cable unit connection <For Argentina> |
|
| 3. |
Transmission control cable assembly connection (selector lever assembly
side) |
||
| 4. |
Harness connector |
||
| 5. |
Selector lever assembly |
||
| • |
SRS-ECU (Refer to GROUP 52B, SRS control unit .) |
||
| 6. |
Transmission control cable assembly |
||
| Selector lever assembly removal steps |
|||
| >>A<< |
2. |
Shift lock cable unit connection <For Argentina> |
|
| 3. |
Transmission control cable assembly connection (selector lever assembly
side) |
||
| 4. |
Harness connector |
||
| 5. |
Selector lever assembly |
INSTALLATION SERVICE POINTS
)
- Install the shift lock cable unit rod to the selector lever assembly lock cam, and tighten the shift lock cable unit installation bolt to the specified torque.
Tightening torque: 5.0 ±
1.0 N·m
- Check the selector lever operation. (Refer to )
)
- Place the cable stud into the manual control lever slot and install the nut loosely. Gently push the transmission control cable into the manual control lever slot until the cable is taut. Tighten the nut to the specified torque.
Tightening torque: 12 ±
2 N·m