)
- Removal the A/T control relay.
)
- Use the jumper leads to connect A/T control relay terminal 2 to the negative battery terminal and terminal 3 to the positive battery terminal.
- Check the continuity between A/T control relay connector terminals 1 and 4 while alternately connecting and disconnecting the jumper leads from the battery terminals.
| Jumper leads |
Continuity between terminals 1 and 4 |
|---|---|
| Connected |
Less than 2 Ω |
| Disconnected |
Open circuit |
- If there is a malfunction, replace the A/T control relay.