|
| |
Inspection
Procedure 3: Does not Move Forward |
|
|
| |
COMMENTS ON TROUBLE SYMPTOM
If the vehicle does not move forward when the selector lever is shifted to D, sport mode
L, or 2 range while the engine is idling, the cause is probably abnormal line pressure or a
malfunction of the underdrive clutch or valve body.
|
PROBABLE CAUSES
- Malfunction of underdrive solenoid valve
- Malfunction of inhibitor switch
- Malfunction of the underdrive clutch
- Malfunction of valve body
- Malfunction of the oil pump
- Malfunction of the engine-A/T-ECU
|
|
|
STEP 1. MUT-II/III actuator test
Item 02: Underdrive solenoid valve
OK: Operating sound can be heard.
Q: Is the check result normal?
YES:
Go to Step 2  .
NO:
Replace the underdrive solenoid valve.
|
STEP 2. MUT-II/III data list
Item 61: Inhibitor switch (Refer to data list reference table  .)
Q: Is the check result normal?
YES:
Go to Step 3  .
NO:
Refer to inspection procedure 16: Inhibitor switch system  <4G63, 4G64>,  <4G69>.
|
STEP 3. Underdrive solenoid valve check
- Turn the ignition switch to the ON position.
- Shift the selector lever from N to D range.
- Confirm the operating sound of the underdrive solenoid valve.
OK: Operating sound can be heard.
Q: Is the check result normal?
YES:
Go to Step 4  .
NO:
Replace the engine-A/T-ECU.
|
STEP 4. Hydraulic pressure test
Measure the hydraulic pressure of the underdrive clutch when the selector lever is at
the L range (Refer to  ).
OK: Refer to  .
Q: Is the check result normal?
YES:
Go to Step 7  .
NO:
Go to Step 5  .
|
STEP 5. Engine-A/T-ECU replacement
- Replace the engine-A/T-ECU.
- Test drive the vehicle.
- Verify that the condition described by the customer exists.
Q: Does a malfunction take place again?
YES:
Go to Step 6  .
NO:
The inspection is complete.
|
STEP 6. Valve body disassembly clean and assembly
- Check the bolts for looseness and the O-ring, solenoid valve and valve body for damage.
Replace the valve body assembly if the damages are thought to be irreparable.
- Test drive the vehicle.
- Verify that the condition described by the customer exists.
Q: Does a malfunction take place again?
YES:
Go to Step 7  .
NO:
The inspection is complete.
|
- If the damage is in the oil pump assembly, replace the oil pump assembly.
- Test drive the vehicle.
- Verify that the condition described by the customer exists.
Q: Is the check result normal?
YES:
Go to Step 8  .
NO:
The inspection is complete.
|
STEP 8. Underdrive clutch check
- Check the facing for seizure and the piston seal ring for damage and interference with
the retainer.
- Test drive the vehicle.
- Verify that the condition described by the customer exists.
Q: Is the check result normal?
YES:
The inspection is complete.
NO:
Repair or replace the underdrive clutch.
|