[13C] MULTIPORT FUEL INJECTION (MPI) <4G69> - - INJECTOR - REMOVAL AND INSTALLATIONPRINT PAGE / INDEX / PRIOR / NEXT
INJECTOR
REMOVAL AND INSTALLATION
Pre-removal Operation
  • Fuel Discharge Prevention (Refer to ).
  • Air Cleaner Removal (Refer to GROUP 15, Air Cleaner ).
Post-installation Operation
  • Air Cleaner Installation (Refer to GROUP 15, Air Cleaner ).
  • Fuel Leakage Inspection.

   



Removal steps


1.
 PCV hose connection


2.
 Capacitor connector


3.
 Ignition coil connector


4.
 Injector connector


5.
 EGR valve connector


6.
 Rocker cover bracket installation bolts

>>A<<
 7.
 Fuel high-pressure hose connection


8.
 O-ring
<<A>>
9.
 Fuel delivery pipe and fuel injector assembly


10.
 Insulators

>>A<<
 11.
 Fuel injector assembly


12.
 Fuel delivery pipe


13.
 O-ring


14.
 Insulators


15.
 Grommets


16
 Fuel injectors

REMOVAL SERVICE POINT
<<A>> FUEL DELIVERY PIPE AND FUEL INJECTOR ASSEMBLY REMOVAL
 CAUTION
 Do not drop the injector.
Remove the fuel delivery pipe with the fuel injector assembly attached to it.
INSTALLATION SERVICE POINT
>>A<< FUEL INJECTOR ASSEMBLY/FUEL HIGH-PRESSURE HOSE INSTALLATION
 CAUTION
 Do not let the engine oil get into the delivery pipe will be damaged.
  1. Apply a drop of new engine oil to the O-ring.
  1. Turn the fuel injector assembly to the right and left to install to the fuel delivery pipe. Repeat for fuel high-pressure hose. Be careful not to damage the O-ring. After installing, check that the item turns smoothly.
  1. If it dose not turn smoothly, the O-ring may be trapped, remove the item, re-install it into the fuel delivery pipe and check again.
  1. Tighten the fuel high-pressure hose to the specified torque.
    2. Tightening torque: 5.0 ± 1.0 N·m
[13C] MULTIPORT FUEL INJECTION (MPI) <4G69> - - INJECTOR - REMOVAL AND INSTALLATIONPRINT PAGE / INDEX / PRIOR / NEXT
©2004 Mitsubishi Motors Corporation