[13C] MULTIPORT FUEL INJECTION (MPI) <4G69> - - ON-VEHICLE SERVICE - ACCELERATOR PEDAL POSITION SWITCH CHECKPRINT PAGE / INDEX / PRIOR / NEXT
ACCELERATOR PEDAL POSITION SWITCH CHECK
       
    1. Disconnect the accelerator pedal position sensor connector.
    1. Check continuity between terminal No. 4 (accelerator pedal position switch) and No. 5 (earth) of the connector.
    Normal condition:
    Accelerator pedal
    		 Continuity
    Depressed
    		 No continuity
    Released
    		 Continuity (0 Ω)
    1. If defective, replace the accelerator pedal position sensor.
      2. NOTE: After replacement, adjust the accelerator pedal position sensor. (Refer to .)
    [13C] MULTIPORT FUEL INJECTION (MPI) <4G69> - - ON-VEHICLE SERVICE - ACCELERATOR PEDAL POSITION SWITCH CHECKPRINT PAGE / INDEX / PRIOR / NEXT
    ©2004 Mitsubishi Motors Corporation