Actuator Test Reference
Table
| Item No. |
Inspection item |
Drive content |
Inspection conditions |
Normal condition |
Code No. /Inspection procedure No. |
Reference page |
|
|---|---|---|---|---|---|---|---|
| 01 |
Injector |
Cut off No. 1 injector |
Engine: After warm-up, idle operation
(Cut off injectors sequentially to check for a cylinder that does not change engine in idle
status. |
Engine is changed (becomes unstable or stalled) |
Code No. P0201 |
 |
|
| 02 |
Cut off No. 2 injector |
Code No. P0202 |
|
||||
| 03 |
Cut off No. 3 injector |
Code No. P0203 |
|
||||
| 04 |
Cut off No. 4 injector |
Code No. P0204 |
|
||||
| 07 |
Fuel pump |
Drive fuel pump to circulate fuel |
Ignition switch: "ON" |
Check for pump operating noise near fuel tank |
Operating noise audible |
Procedure No. 25 |
|
| 08 |
Purge control solenoid valve |
Switch solenoid valve from OFF to ON |
Ignition switch: "OFF" |
When the valve is actuated, operating noise is audible |
Code No. P0443 <Vehicles for Hong kong> |
|
|
| 17 |
Basic ignition timing |
Switch engine-A/T-ECU to ignition timing adjusting mode |
|
5°
BTDC |
- |
- |
|
| 21 |
Fan controller |
Actuate fan motor |
|
Fan motor is rotated |
Procedure No. 22 |
|
|
| 22 |
Oil control valve |
Oil control valve turns from OFF the ON |
Ignition switch: "ON" |
Clicks when oil control valve is driven |
Code No. P1021 <Vehicles for Hong kong> |
|
|
| 34 |
Throttle valve control servo |
Stop the throttle valve control servo |
Ignition switch: "ON" |
Throttle valve is open |
Code No. P2100, P2101, P2102, P2103 |
|
|