[33] FRONT SUSPENSION - - LOWER ARM - REMOVAL AND INSTALLATION <2000-DOHC AND 2400>PRINT PAGE / INDEX / PRIOR / NEXT
REMOVAL AND INSTALLATION <2000-DOHC AND 2400>
 CAUTION
 * : Indicates parts which should be temporarily tightened, and then fully tightened with the vehicle on the earth in an unladen condition.
Post-installation Operation
  • Check the dust cover for cracks or damage by pushing it with your finger.
  • Front Wheel Alignment Check and Adjustment (Refer to ).

   



Removal steps


1.
 Lower arm and knuckle connection

>>A<<
 2.
 Self-locking nut


3.
 Stabilizer rubber


4.
 Stabilizer link assembly


5.
 Lower arm and crossmember connection


6.
 Lower arm assembly

INSTALLATION SERVICE POINT
>>A<< SELF-LOCKING NUT INSTALLATION
   
Tighten the self-locking nut until the stabilizer link thread part protruding length meets the standard value.
Standard value (A): 9.4 ± 0.4 mm
[33] FRONT SUSPENSION - - LOWER ARM - REMOVAL AND INSTALLATION <2000-DOHC AND 2400>PRINT PAGE / INDEX / PRIOR / NEXT
©2004 Mitsubishi Motors Corporation