<L.H. DRIVE VEHICLES>
NOTE: The ABS-ECU is integrated in the hydraulic unit.
Pre-removal Operation
|
Post-installation Operation
|
)
| Removal steps |
|||
|---|---|---|---|
<<A>> |
1. |
Harness connector |
|
| >>A<< |
2. |
Brake pipe connection |
|
| <<B>> |
3. |
Hydraulic unit and ABS-ECU |
|
| 4. |
Hydraulic unit bracket assembly |
<R.H. DRIVE VEHICLES>
NOTE: The ABS-ECU is integrated in the hydraulic unit.
Pre-removal Operation
|
Post-installation Operation
|
)
| Removal steps |
|||
|---|---|---|---|
| <<A>> |
1. |
Harness connector |
|
| >>A<< |
2. |
Brake pipe connection |
|
| <<B>> |
3. |
Hydraulic unit and ABS-ECU |
|
| 4. |
Hydraulic unit bracket assembly |
REMOVAL SERVICE POINTS
)
Move the lock lever of the ABS-ECU connector as shown in the illustration, and then disconnect the harness connector.
WARNINGINSTALLATION SERVICE POINT
)
Connect the pipes to the hydraulic unit assembly as shown in the illustration.
- From the master cylinder (secondary)
- To the front brake (LH)
- To the rear brake (RH)
- To the rear brake (LH)
- To the front brake (RH)
- From the master cylinder (primary)